It is a L298N Control Module Dual H Bridge DC Stepper Motor Drive Controller Board Module, Drive Terminal Power Supply: +5V~+25V, Applied to Arduino/ Robot/ Smart Car etc

Dual H Bridge DC Stepper Motor Drive Controller Board Module L298N
Driver: L298N Dual H Bridge DC Motor Driver IC
Parameters:

• Driver: L298N Dual H Bridge DC Motor Driver IC
• Drive Terminal Power Supply: +5V~+25V; (if others need to be powered by the board, power supply should be +7V~+25V)
• Drive Part of the Peak Current: 2A     
• Logic Terminal Power Supply: +5 V ~ +7 V (Power supply within the board: +5 V)
• Logic Part of the Operating Current: 0 ~ 36mA
• Control Signal Input Voltage Range:
  
  • Low: -0.3V ≤ Vin ≤ 1.5V;
  • High: 2.3V ≤ Vin ≤ Vss
• Enable Signal Input Voltage Range:
  • Low: -0.3 ≤ Vin ≤ 1.5V (control signal is inactive);
  • High: 2.3V ≤ Vin ≤ Vss (control signal active)
• Maximum Power Consumption: 20W ( at 75 °c )
• Storage Temperature: -25 °c ~ +130 °c
• Other Extensions: Control indicators, logic unit power supply interface
• Size: 48 x 43 x 33mm (L x W x H) (Includes the height of copper pillar and heat sink)
• Weight: 33g

Package includes:

• 1 x L298N Dual H Bridge Stepper Motor Driver Controller Board