You are here:>>9V Voltage Regulator, DROK DC Buck Converter 5V-23V 12V to 0.01-18V 5V Power Sup
9V Voltage Regulator, DROK DC Buck Converter 5V-23V 12V to 0.01-18V 5V Power Sup 2020-10-13T20:06:11+00:00

Home Forums Voltage Regulator Support 9V Voltage Regulator, DROK DC Buck Converter 5V-23V 12V to 0.01-18V 5V Power Sup

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • Barry Klein
    Post count: 0

    How do I adjust the output voltage back down?  It is staying at maximum even though I press the left button.

     

    Drok
    Keymaster
    Post count: 2971

    Hello Barry Klein,

    According to your descritpion, it should be this item, #180079, https://www.amazon.com/dp/B07LC4LNTD/ref=as_li_tl?tag=proeng-20

    Could you please tell us how large the input voltage is? How about the right button?

    Best regards,

    DROK

    • This reply was modified 3 years, 5 months ago by  Drok.
    Barry Klein
    Post count: 0

    I don’t have it hooked up any longer but can try it again.  My input was an adjustable bench supply, capable of >12VDC.

    It was staying set at the set voltage between power ups ok, but it would just not adjust down.  Perhaps bad left switch then?

    Drok
    Keymaster
    Post count: 2971

    Hello,

    Is it 12v input in that case? If both button can’t work, would you please try to calibrate voltage reading?

    You can find calibration method from instruction or refer to below steps.

    1. Hold the left button and connect power supply, then release button, screen will start flasing

    2. Check the actual output voltage with multimeter. Then adjust voltage reading with left or right button unitl it is the same as multimeter reading. Calibration data will be saved automatically after 2 seconds.

    3. Power off and power again, calibration is finished. Error can be ±0.01V. If error is larger, you can calibrate again.

    If it still not work, would you like to show us your operation so that we can check further?

    Best regards.

     

     

Viewing 4 posts - 1 through 4 (of 4 total)
Reply To: 9V Voltage Regulator, DROK DC Buck Converter 5V-23V 12V to 0.01-18V 5V Power Sup
Your information: