Home › Forums › Voltage Regulator Support › adjustable 24 volt 20 amp switch power supply
-
AuthorPosts
-
Dave Pellegrino
September 13, 2022 at 4:08 pmPost count: 0Hello,
I’m trying to find a manual for this item with SKU number 200624
I would like to know what the switch is for on the left side under the voltage adjust potentiometer.
What is the default position?
What is the other position for?
What is the No-Load adjusting current instructions about and for. Please provide an example.
Very confusing and lacking with your directions.
Hello Dave Pellegrino,
Did you receive this manual? https://www.droking.com/cs/wp-content/uploads/2022/09/200624_200625.pdf
The switch is pushed left, you can adjust current limit value. If it is pushed right, that is to open output.
About no-load current adjustment, without load, current is zero, which can’t be adjusted, so you need to pull out the metal insert under current adjustment then connect output port. After adjustment, please put back the metal insert.
If you don’t need to limit current, you can neglect that, just push switch right and turn current potentiometer clockwise to maximum.
Best regards,
Dave Pellegrino
September 15, 2022 at 2:16 pmPost count: 0I don’t understand this.
“The switch is pushed left, you can adjust current limit value. Before a load is connected? When I push to the left, the voltage drops down.
If it is pushed right, that is to open output.” What does this mean? If output only needs 10 amps, then that’s all that will be supplied? What if output varies as time goes on, say that initially the load requires 20 amps, then as time goes on, it slowly requires less amps, but constant 24 volts
“About no-load current adjustment, without load, current is zero, which can’t be adjusted, so you need to pull out the metal insert under current adjustment” Are you talking about the 50amp fuse?
“then connect output port.” What output port? Connect to what?
“After adjustment, please put back the metal insert.” The fuse?
Thank you…
Hello Dave Pellegrino,
When switch is push right, that is for current limit setting. Without load, current is zero, so we clarify what is no-load current adjustment, as shown below.
About no-load current adjustment, without load, current is zero, which can’t be adjusted, so you need to pull out the metal insert under current adjustment then connect output port. After adjustment, please put back the metal insert.
Notice: the metal insert is not fuse, it work as load so that you can adjust current valule, please connect it to the second +V and the third -V.
Dave Pellegrino
September 22, 2022 at 2:32 pmPost count: 0Hello Dave Pellegrino,
Notice: after adjustment, please upplug the metal from output ports, just put back
No converter can control how much current the load should draw, actual output current mainly depend on load. Converter only regulate current when load current is over preset limit. For example, preset value is 10A, load draw 20A,it will limit load current to 10A.
Dave Pellegrino
September 26, 2022 at 10:12 pmPost count: 0 -
AuthorPosts