Amplifier – connect power

[Jon Perryman February 25, 2016 at 5:02 am Post count: 0]

#3508 Reply |

I ordered the 10w amplifier with with the wire terminals but I received the one with the power socket. Can I solder the power wires to the underside of the board? If so, which pins are the + & -? My guess is that it’s 2 of the three pins (2 directly under socket and 1 to the side). Or am I better off just sending it back to get the one I actually need?

Thanks, Jon.

[DrokKeymaster February 25, 2016 at 7:32 am Post count: 2971]

#3510 Reply |

Hello Jon Perryman，
Thank you for purchasing.
Could you please tell us your order ID or the ASIN of the product you purchased?
Thanks

[Jon Perryman February 25, 2016 at 2:44 pm Post count: 0]

#3512 Reply |

ASIN B010LKFXVY. My boss orders so much from Amazon that it’s difficult to get an order ID.

It looks like I received the TYPE_5.5_SOCKET which is a hyperlink from https://www.amazon.com/dp/B010LKFXVY

Thanks, Jon.

[DrokKeymaster February 26, 2016 at 2:43 am Post count: 2971]

#3518 Reply |

Hello Jon Perryman,
Thank you for writing in and your cooperation.
You can try to solder the power wires to the underside of the board.
Here is the picture to show you which pin is the +&-:

Hope this will be helpful to you.
Best regards

[Jon Perryman February 26, 2016 at 3:31 pm Post count: 0]

#3522 Reply |

Thank you very much. This will work for me.

Thanks, Jon.

[Author]

Posts