You are here:>>Correct setup/programming of SKU 2001710003 10-100V Digital Battery Capacity te
Correct setup/programming of SKU 2001710003 10-100V Digital Battery Capacity te 2019-04-29T02:16:00+00:00

Home Forums Panel Meter Support Correct setup/programming of SKU 2001710003 10-100V Digital Battery Capacity te

Viewing 8 posts - 16 through 23 (of 23 total)
  • Author
    Posts
  • Brent Meeker
    Post count: 0

    I have an SKU:2001712003.   I can’t get the battery amp-hour specification to setup correctly.  I have 12v lead acid, 3ah battery.  I go thru the “Button Instructions” 4. Setting parameters.  I set AH003.0 and FU012.7 and leave the other three LU, HU, HA all zero.  I wait until the display goes back to normal.  The display then shows the battery capacity as empty and the remaining capacity as 24.6.  I’ve gone thru it a couple of times setting AH003.0, but it always comes back 24.6???

    Drok
    Keymaster
    Post count: 2971

    Hello,

    Please kindly notice you need to fully charge battery again after setting. And the charging current must flow through the current sensor, or it can’t show correct battery capacity.

    José
    Post count: 0
    This reply has been marked as private.
    Drok
    Keymaster
    Post count: 2971

    Hello José,

    Are you talking about the #2001710003? Could you please tell us more details about your problem?

    Mike N.
    Post count: 0

    I have a dual 48v Lithium battery setup in my golf cart. I set mine to L-2 under menu #1. The meter shows the battery at 100% and does not drop even after using the cart. What did I do wrong?

    Drok
    Keymaster
    Post count: 2971

    Hello Mike N.

    Are you talking about the 2001710003? Please notice  one litium battery voltage is  4.2v in this program, then L2 means  4.2v*2=8.4v instead of 48v.

    Best regards.

    DROK

    Enoch
    Post count: 0
    This reply has been marked as private.
    Renato Abu Hana
    Post count: 0

    Hi I have a 48v Golf Cart. Just  bought 6set of battery Trojan 8V.

    The monitor is not accurate and I am not sure how to set it up.

    In the first menu:

    1) I set up 48V

    3) not sure which voltage range should I use. The guy that sold me the batteries said low: 48v and high 56,4v. Is that correct?

     

    although I tried that. The battery only show  up to 75%.

    can you guys help to to configure it ?

    thank you

Viewing 8 posts - 16 through 23 (of 23 total)
Reply To: Correct setup/programming of SKU 2001710003 10-100V Digital Battery Capacity te
Your information: