How to wire 200219 voltmeter to shut off load using relay and switch?

[Joe Adkins June 27, 2020 at 6:08 am Post count: 0]

#40139 Reply |

Looking at the instruction manual for 200219 voltmeter, I wasn’t sure how to wire in a switch to shut off load using a switch/relay?   I found someone else on this forum that had this drawn up, but wasn’t sure if this would shut off the inverter with my switch?

Again, I want to use a 2pole switch to shut off the inverter, leaving the 200219 powered on.  Will this configuration work in this way?

[DrokKeymaster June 28, 2020 at 9:46 am Post count: 2971]

#40197 Reply |

Hello Joe Adkins,

“-Vext+”  is independent power  port for item. If you want to leave item on, please connect independent power supply for it.  Now your switch is to control the power to our item instead of inverter.

“-Relay+” is connected to relay. If you are not going to connect relay, please ignore it. It can’t accept  pwoer input. Once your connect power to “”- Vext+“， relay can be powered on. ” It seems your  connection on “-Relay+” is conflict.

Please refer to Image1-3  in our insruction.

https://images-na.ssl-images-amazon.com/images/I/D1xd3n-y-DS.pdf

Best regards.

 

[Author]

Posts