-
AuthorPosts
-
Bart V
February 14, 2019 at 9:28 pmPost count: 0Hello,
I have a problem with my meter. When there are no loads or charging sources connected, the ammeter show a charge current of between 1 and 2 amps at all times. It is hooked up per the instructions at https://www.droking.com/cs/wp-content/uploads/2018/08/200193-instruction.pdf and was originally showing 0 amps, but has changed over time.
The instructions show no method of calibrating. How can this be achieved, please?
Thank you,
Bart
Hello Bart V,
You may try zero clearing。
1.Please move the red cursor to “NCP”,
2. Keep pressing up button for 3 seconds. After that, there will be 3 options.
3. Make the red cursor pointing to C-I, and press “OK” button. Then you will see “I=0”, at this time, please press up or down button to reset. (Please notice when in the reset process, it can’t be connected with any load)
4. Press “OK” button again, you will see “I>0”(connect a 3A load). Then press up or down button to make the current value is in accord with 3A load. Press “Ok” button to save settings.
Best regards。
Michael81
November 14, 2025 at 9:40 amPost count: 0Hey, ik had laatst een soortgelijk probleem waarbij ik na een lange dag werken gewoon iets ontspannends wilde doen. Ik stuitte toevallig op duospin casino en was meteen nieuwsgierig naar hun bonusaanbod voor spelers uit Nederland. Ik probeerde de Mega Fortune slot uit en het was verrassend hoe soepel alles draaide, na een paar kleine verliezen kwam er ineens een mooie winst die mijn avond helemaal goedmaakte. Het voelde alsof die paar spins echt mijn geluk veranderden, en sindsdien speel ik er regelmatig als ik even wil ontspannen en een beetje spanning zoek. Het is echt een leuke manier om de stress van de dag van je af te zetten.
-
AuthorPosts
Current zero calibration for 0-120V DC 0-100A Digital Multimeter
2019-02-14T21:28:21+00:00
Viewing 3 posts - 1 through 3 (of 3 total)
Viewing 3 posts - 1 through 3 (of 3 total)