You are here:>>091029US Display turns off after a few minutes
091029US Display turns off after a few minutes 2019-05-05T22:42:45+00:00

Home › Forums › Voltage Regulator Support › 091029US Display turns off after a few minutes

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • Ed Morth
    May 5, 2019 at 10:42 pm
    Post count: 0
    #35849 Reply |

    I have a 091029US buck power supply that works great. The display turns off after a few minutes.  Is this normal?  Is there a way to keep it on continuously?

    Thanks, Ed

    Drok
    Keymaster
    May 7, 2019 at 10:04 am
    Post count: 2971
    #35861 Reply |

    Hello Ed Morth,

    Thanks for writing in.

    After turning off, can it power on again? Or is it always off now? And could you please tell us the input and output parameters?

    Best regards.

    Ed Morth
    May 8, 2019 at 10:32 pm
    Post count: 0
    #35868 Reply |

    Input voltage: 17 VDC, output voltage 7.0 VDC, current limit 1.5 Amps

    It continues to work after the display goes off.  7.0 volts output.  CC/CU, Charge and Full LEDs continue to work.  In and Out LEDs do not work.

    Yes, display comes back on after power up.  The display stays on for several minutes (5 to 20 minutes) and then goes off.  I removed the button on the left thinking it may be defective.  No impact, the display still goes off.

    I am an electronics engineer and have been building projects for many years.

     

    Drok
    Keymaster
    May 9, 2019 at 7:46 am
    Post count: 2971
    #35871 Reply |
    This reply has been marked as private.
  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
Reply To: 091029US Display turns off after a few minutes
Your information: