Home › Forums › Voltage Regulator Support › 2001708006: Voltage variation among devices
Are there better pictures showing how the traces at “ADJ” should look when using the soldered voltage selections?
P/N: <span class=”p-model”>2001708006</span>
Hello Matt,
Thanks for writing in.
If you select fixed output voltage by soldering the pot on the board，it doesn’t matter how the potentiometer is.
Best regards.
I was referring to the “cut” required at the top trace. It appears that needs to be done as well as the pad soldering. That cut is what I’d like a better picture of.
Hello,
Please refer to this picture.
Name (required):
Mail (will not be published) (required):
Website:
Set as private reply
Enter the destination URL
Or link to existing content
Matt
