DROK Battery Monitor #2001710003 with 3 lithium batteries how to program

Viewing 3 posts - 1 through 3 (of 3 total)

Author

Posts
fred
November 3, 2021 at 3:18 am

Post count: 0

#83797 Reply |

I purchased a DROK 10-100v Battery Monitor #2001710003 from Amazon and I need instructions on how to correctly program it for 3 Lithium LiFePO4 12v 60Ah batteries hooked in series.

At full charge the monitor reads 39.9v and 100% capacity. After discharging the batteries for a period of time the monitor reads 39.4 volts, but still shows that there is 100% capacity. How can the batteries be at 100% capacity after they have been discharged for a period of time?

How do you program the DROK 10-100v Battery Monitor #2001710003 to accurately measure the battery capacity of the 3 Lithium LiFePO4 12v 60Ah batteries hooked in series?

Thank you in advance for your help!

Drok
Keymaster

November 3, 2021 at 9:36 am

Post count: 2971

#83807 Reply |

Hello fred,

Please refer to rated battery voltage instead of battery cell quantity. In this program , one cell of lithium iron phosphate is 3.2v, assume your battery is 12v, you can select “F4″(3.2V*4) in menu”1–“.

If there is no suitable battery specification in menu 1, please program menu “3–“, custom setting.

For more deails, please refer to instruction, https://m.media-amazon.com/images/I/911LJfacaVL.pdf

Best regards,

DROK

Art E
April 14, 2025 at 11:58 pm

Post count: 0

#124361 Reply |

Although I have the instructions for setting up the Drok 10-100v, I cannot seem to set it up. Is it broken? Here is what I’m doing:
Entered menu 1– enetered F4 for my 12v LIFEPO4 100ah battery. Then long pressed power button to save that parameter but it just erases the F4 and I have to try again. And again. And again. So, I cannot even seem to setup the 1st parameter, setting up battery type!

Also, would this work (be the same setup) for 2 or 3 12v LIFEPO4 batteries in parallel?

Thank you
AE.
Author

Posts

Viewing 3 posts - 1 through 3 (of 3 total)