Home › Forums › Voltage Regulator Support › Drok DKP6012 Overheating
The fan only turns on at 5A or above and it is getting very hot. How can this be adjusted?
Can you link the board schematic?
Hello Fexa,
We are sorry factory doesn’t allow to show schematic. AnD The starting current can’t be adjusted by user.
Is there large voltage difference between input and output?
Best regards,
DROK
This is a fantastic module so I’m disappointed with the starting current support. Is it set in hardware or firmware?
Yes, huge voltage difference. House solar panels to 12V.
Hello,
With large voltage difference, power loss will also increase. If possible, it is better to lower votlage diffrerence.
Best regards.
Name (required):
Mail (will not be published) (required):
Website:
Set as private reply
Enter the destination URL
Or link to existing content