You are here:>>WLS-PVA200
WLS-PVA200 2022-02-12T00:38:35+00:00

Home Forums Panel Meter Support WLS-PVA200

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • chung nieh
    Post count: 0

    Anyone can tell me that what are three readings on this meter maenad: one is at upright corner(show AH), second one is at bottom right corner(shown W) and third is at left bottom corner(also shown W). Also there were + and – signs associated with it. There was a “battery bar” at upper left corner, how it can be programmed to reflex real capacity.  Thanks.

    Drok
    Keymaster
    Post count: 2971

    Hello chung nieh,

    Here is manual for your reference, https://m.media-amazon.com/images/I/91by7p202GL.pdf

    Any more questions, please let us know.

    Best regards.

    Dave Williams
    Post count: 0

    I have the WLS-PVA200, in setup there are several settings not addressed in the instruction sheet:

    CU

    RA

    AU

    Could you please advise what they are for and their function?

    Drok
    Keymaster
    Post count: 2971

    Hello Dave Williams,
    These settings are not availalbe on this version, you can just ingore that

    Dave Williams
    Post count: 0

    on my WLS-PVA200 I reset the current and with no flow (nothing going through the loop) it shows .02, shouldn’t it be “0”?  When I put the load in it does show a reading however it is not accurate, it reads very low.  I put a Fluke ammeter on to check it.  for example the fluke shows .8 and the DROK shows .4. as the actual load increases the difference increases.

    Drok
    Keymaster
    Post count: 2971

    Hello Dave Williams,

    May I know how you rese current? Did you reset currnt without load?

     

    Bob
    Post count: 0

    Is there a way to factory reset this meter? The battery % charge reading toggles from 0 a/hrs to 35%?

Viewing 7 posts - 1 through 7 (of 7 total)
Reply To: WLS-PVA200
Your information: