You are here:>>ZK-DP60
ZK-DP60 2021-01-28T16:24:52+00:00

Home › Forums › Voltage Regulator Support › ZK-DP60

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Sam Bingham
    January 28, 2021 at 4:24 pm
    Post count: 0
    #58665 Reply |

    I purchased this in December for a project 12vdc input needing 24vdc output to run an HMI I installed it this morning and everything worked great for about 5 minutes. My output was 24vdc .250 amps on display after 5min display started going on and off with no output disconnected HMI display will come on until you turn output on then will only turn on and off with no load connected.

    Drok
    Keymaster
    January 29, 2021 at 8:51 am
    Post count: 2971
    #58744 Reply |

    Hello Sam Bingham,

    We think it should be this item, http://www.amazon.com/dp/B07VNDGFT6?ref=myi_title_dp

    May I know how large the input current in that case?  Would you like to show how it is by video so that we can check further?

    You can share a video link here or send video attachment to service@droking.com.

    Best regards,

    DROK.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: ZK-DP60
Your information: