Parameters:

• Input voltage range: DC 10~50V
• Output voltage: linear (with load)
• Output limit current: 40A (long time use 20A, pay attention to heat dissipation)
• Limit power: 2000W
• Speed regulation type: flow control
• Speed regulation mode: potentiometer (linear)
• Speed duty cycle range: 0~100%
• Control frequency: 25KHZ
• Wiring type: barrier terminals
• Knob line length: 20CM
• Potentiometer installed hole: 7MM
• Note: Make sure the positive and negative connections are correct before the power is on. Do not touch the heatsink or the circuit board may be burnt. Note that this is not a power module, you must connect to the motor then you can regulate speed. Cannot connect to the AC power.

Package Including:

• 1 x PWM Motor Controller ( DC Controller/Speed Controller )