You are here:>>6.5-100v 20 amp internal shunt panel meter
6.5-100v 20 amp internal shunt panel meter 2016-10-26T13:22:29+00:00

Home › Forums › Panel Meter Support › 6.5-100v 20 amp internal shunt panel meter

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • Dan Andrews
    October 26, 2016 at 1:22 pm
    Post count: 0
    #10038 Reply |

    I need a wiring diagram of how to connect the wiring to monitor the voltage and current from my solar panels.to my charge controller.
    Thanks.

    Drok
    Keymaster
    October 27, 2016 at 1:36 am
    Post count: 2971
    #10055 Reply |

    Hello Dan Andrews,
    Thank you for writing in.
    Here the PDF file is the datasheet of the product, please check it.
    DATASHEET_200139
    Hope this is helpful to you.
    Best regards

    Dan Andrews
    October 27, 2016 at 1:07 pm
    Post count: 0
    #10070 Reply |

    Drok
    Keymaster
    October 28, 2016 at 1:55 am
    Post count: 2971
    #10084 Reply |

    Hello Dan Andrews,
    Thank you for writing in.
    What can we do for you?
    Best regards

    Joris
    December 30, 2016 at 11:36 am
    Post count: 0
    #11309 Reply |

    Hello, just a question
    we bought the
    DROK® Digital Multimeter DC 6.5-100V 100A Voltage Amperage Power Energy Meter
    and the question is:
    What is the recommended maximum cable length and cable thickness for the sensor cables from the shunt to the meter?
    We were wondering if it could be about 2m, would that influence the measurements?
    thanks Joris

    Drok
    Keymaster
    January 2, 2017 at 3:04 am
    Post count: 2971
    #11345 Reply |

    Hello Joris,
    Thank you for writing in.
    There is no exact demand of the cable length and cable thickness, which is depend on the power supply and the load in your application.
    For the cable length, it is recommended that the length is within 1 meter.
    If the length is too long, the measuring result of current may be not accurate.
    Hope this can help you.
    Best regards

    Jonathan Mayberry
    January 10, 2017 at 1:45 am
    Post count: 0
    #11517 Reply |

    Hello, I have this 6.5-100v 20 amp dc meter and the AMP reading is way off. Is there any way to calibrate the amp reading?

    Drok
    Keymaster
    January 15, 2017 at 9:27 am
    Post count: 2971
    #11595 Reply |

    Hello Jonathan,
    Thank you for writing in.
    Could you please send us the link of product you mention?
    We can’t ensure which product you mention.
    Please don’t worry, we will try our best to find solution for you.
    Best regards.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
Reply To: 6.5-100v 20 amp internal shunt panel meter
Your information: