You are here:>>Almost immediate over temp shutdown Adjustable Voltage Regulator
Almost immediate over temp shutdown Adjustable Voltage Regulator 2022-12-23T03:44:04+00:00

Home Forums Voltage Regulator Support Almost immediate over temp shutdown Adjustable Voltage Regulator

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • dj
    Post count: 0

    I have a Adjustable Voltage Regulator DC, DROK Buck Boost Converter 6.0V-36V 9v 12v to DC 0.6-36V 24v 5A Power Supply Panel, Constant Current Volt Step Up Down Module that is heating up within a minute and giving me an over temp shutdown.  After 20 seconds or so after the temp drops it turns back on.  But it hits over temp within a minute each time.  Running on a 12v 20 switched power supply stepping down to 5v 2A.   I do hear the fan turn on before over temp but it still shuts down.

    I am guessing something is defective in the unit.  If I adjust the max temp cut off, it runs to that temp.  I was in a room that was not hot and it typical for the environment of 80 degrees F.

     

    Can you give me some direction or is it defective?  Please advise,

    Duane

    Drok
    Keymaster
    Post count: 2971

    Hello dj,

    Please check if it is this item, https://www.amazon.com/dp/B089ND7PTH?ref=myi_title_dp&th=1

    Did it show “OPP” ? Would you like to show how it is by images or video?

    Best regards,

    DROK

    dj
    Post count: 0

    Yes, that is the item I bought.

    dj
    Post count: 0

    I will try to get a picture of the over-temp error.  Thank you.

    dj
    Post count: 0

    Sorry, it has taken a while to get the picture.  The part was on a project that was not at my house and the holder was on vacation for the holiday.

    https://www.dropbox.com/s/2nk4too7gczgj2n/2023-01-05%2017.22.19.jpg?dl=0

    Drok
    Keymaster
    Post count: 2971

    Hello, dj

    According to your image, that is over-temperture protection,  how do you set the OTP paramters?

    dj
    Post count: 0

    When I first plugged it in, it was at default temp.  Almost immediately it went over temp. I don’t remember the default temp it was at but it was really quite low. I tried increasing the temp a bit and it still would quickly go over temp.  What temp should I be setting the over-temp limit to?

    dj
    Post count: 0

    The output voltage, current and temp were the only parameters I changed.  I set to 5.05v and  1.5A.

    dj
    Post count: 0

    Just saw your note that your office is closed till Jan 28. I’ll sit tight.  Thank you.

Viewing 9 posts - 1 through 9 (of 9 total)
Reply To: Almost immediate over temp shutdown Adjustable Voltage Regulator
Your information: