Home › Forums › Voltage Regulator Support › B01GNNLYX4 900W Instructions
-
AuthorPosts
-
Roberto
November 17, 2016 at 1:26 pmPost count: 0Dear Sirs, I bought from AMAZON a B01GNNLYX4 900W DC Boost-Converter and I can see it is a very nice product. However, I am unable to operate it because the instruction sheet included with the Converter are very difficult/impossible to understand and the operation of the Converter is not easy. PLEASE make a review of the instructions in good technical English. Your product deserves it. Please let me know if better ibstructions are available.
Thank you very much– RobertoHello Roberto,
Thank you for your appreciation to our product and so sorry for the inconvenience caused on you.
We will reflect this issue to our technical team, but making a new instruction will need some time.
If you have any confusion of this product, please feel free to contact us.
We will try our best to find a solution to you.
Great thanks for bringing this matter to our attention.
Best regardsRoberto
November 18, 2016 at 2:01 pmPost count: 0Thank you for kind assistance. I take advantage now of your help. Please give me the STEP-BY-STEP procedure to do the following:
1) Fix the output Voltage to 100 V
2) Store this value to memory.
3) Limit the output Current to 100 mA
4) Store this value to memory
5) Limit the input Voltage/Current to 16 V and 1.5 A
6) Store these values to memory
Thank you for your kind help
RobertoP.S. I have observed that the reading of the display does not match the output voltage. I have obtained an output voltage of 100 V (reading on the display), but my Voltmeter reads only about 90 V. Can you please explain if I am doing something wrong.
Hello Roberto,
You’re welcome.
Adjust the output voltage and current of constant current function:
The display will display the set voltage value in default when the module is powered on. The display format of voltage is “00.00”. Pressing “SET” button can switch the to display current. The display format of current is “0.00R”. Choosing the parameter you want to adjust by “SET” button, then pressing ↑/↓button to increase/ decrease the set value. Short pressing can fine down the value while long pressing can fast set the value. After adjusting the value to the one you want, press “SET” button and then the display will become”——“, which means the current voltage/current value is stored. This value will be stored in M0 data group in default. At last, press “OK” and the output will be turned on.
In the state with output, when the module displays output voltage value, pressing ↑/↓button can adjust the output voltage value; when the module display current, pressing ↑/↓button can adjust the current value. In case with output, short press “OK” button can switch the voltage display and current display. Long-pressing for 3 seconds, the voltage and current will display in turn automatically and long-pressing again can turn it off. When the voltage and current display in turn, the ↑/↓button cannot work.The output current is according to the need of the load in your application, which cannot be limited.
The current adjusted here is the value of constant current. If the output current is higher than this value, the module will turn into the state of constant current.The input voltage and current cannot be limited. We can only limit the output voltage.
Hope this can help you.
Best regardsRoberto
November 21, 2016 at 1:15 pmPost count: 0 -
AuthorPosts
