You are here:>>DROK LTC1871 Hole dimensions
DROK LTC1871 Hole dimensions 2016-05-17T00:54:02+00:00

Home › Forums › Voltage Regulator Support › DROK LTC1871 Hole dimensions

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • Todd
    May 17, 2016 at 12:54 am
    Post count: 0
    #4969 Reply |

    I need the dimensions and placement of the four holes on the DROK LTC1871 board. Hole diameters and positions of hole centers relative to a board edge/corner/center or something. I want to create a CNC milled fixture and I need the proper spacing for the holes.

    Thanks

    Drok
    Keymaster
    May 17, 2016 at 2:25 am
    Post count: 2971
    #4971 Reply |

    Hi Todd,
    Thank you for writing in.
    The hole diameter is 3.2mm-3.5mm, 3mm Screw will be suitable.
    The Center distances of the holes are 5.8mm and 3.4mm.
    Hope this can help you.
    Best regards

    Todd
    May 17, 2016 at 4:37 am
    Post count: 0
    #4978 Reply |

    Thank you. Can you clarify the hole positions? What is the distance between holes in the X and Y dimensions of the board? I’m not sure I understand the dimensions you specified in the previous reply.

    Todd
    May 17, 2016 at 2:51 pm
    Post count: 0
    #4981 Reply |

    _____________________________
    | O<———–A———->O |
    | ^ |
    | | |
    | B |
    | | |
    | O O |
    ______________________________

    Hopefully the crude diagram above comes out. I’m looking for dimension “A” and dimension “B” between the holes “O”

    Thanks.

    Todd
    May 17, 2016 at 2:52 pm
    Post count: 0
    #4982 Reply |

    That didn’t work like I meant it to work. 🙂

    Drok
    Keymaster
    May 18, 2016 at 1:44 am
    Post count: 2971
    #4988 Reply |

    Hi Todd,
    Sorry for our poor expression.
    The dimension of “A” is 5.8mm and the dimension of “B” is 3.4mm.
    Hope this can help you.
    Best regards

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
Reply To: DROK LTC1871 Hole dimensions
Your information: