DROK LTC1871 Hole dimensions

[Todd May 17, 2016 at 12:54 am Post count: 0]

#4969 Reply |

I need the dimensions and placement of the four holes on the DROK LTC1871 board. Hole diameters and positions of hole centers relative to a board edge/corner/center or something. I want to create a CNC milled fixture and I need the proper spacing for the holes.

Thanks

[DrokKeymaster May 17, 2016 at 2:25 am Post count: 2971]

#4971 Reply |

Hi Todd,
Thank you for writing in.
The hole diameter is 3.2mm-3.5mm, 3mm Screw will be suitable.
The Center distances of the holes are 5.8mm and 3.4mm.
Hope this can help you.
Best regards

[Todd May 17, 2016 at 4:37 am Post count: 0]

#4978 Reply |

Thank you. Can you clarify the hole positions? What is the distance between holes in the X and Y dimensions of the board? I’m not sure I understand the dimensions you specified in the previous reply.

[Todd May 17, 2016 at 2:51 pm Post count: 0]

#4981 Reply |

_____________________________
| O<———–A———->O |
| ^ |
| | |
| B |
| | |
| O O |
______________________________

Hopefully the crude diagram above comes out. I’m looking for dimension “A” and dimension “B” between the holes “O”

Thanks.

[Todd May 17, 2016 at 2:52 pm Post count: 0]

#4982 Reply |

That didn’t work like I meant it to work. 🙂

[DrokKeymaster May 18, 2016 at 1:44 am Post count: 2971]

#4988 Reply |

Hi Todd,
Sorry for our poor expression.
The dimension of “A” is 5.8mm and the dimension of “B” is 3.4mm.
Hope this can help you.
Best regards

[Author]

Posts