DROK XY-LJ02 acting to refine impulses from a commercial programmable 6v timer

Viewing 3 posts - 1 through 3 (of 3 total)

Author

Posts
Stephen Hansen
June 16, 2020 at 10:07 pm

Post count: 0

#39651 Reply |

The problem involves a commercially available system that uses a 6v DC electric motor to disperse feed, a 6v battery as power source, commanded by a multiprogrammable timer (time of day and duration, impulse to load). Limiting is that the provided timer only allots feed dispersal for intervals of whole seconds. I seek to refine impulse durations down to tenths of a second (for example, alter output to the electric motor for 2.5 rather than 2.0 seconds) . Can the DROK XY-LJ02 when integrated into this system accomplish my aim?

>If so, how would I set-up and wire the XY-LJ02?

How would I wire the XY-LJ02 into the system’s circuitry?

Drok
Keymaster

June 17, 2020 at 8:23 am

Post count: 2971

#39669 Reply |

Hello,

Timing can be xxx.x . But we are not sure if its working mode meet your requirement. Except P6, other modes need to work with trigger signal. Here is instruction, https://images-na.ssl-images-amazon.com/images/I/91z+BlySwmL.pdf

Best regards,

DROK

Kevin Franz
July 1, 2026 at 11:33 pm

Post count: 0

#133411 Reply |

My company is looking to buy 100s of the XY-LJ02 from your company IF we can get them loaded with the firmware version that allows for the P6 cycle to be triggered by the trigger switch and ignores retriggers until the cycle completes. After asking Chat GPT it said that there is a firmware version for the XY-LJ02 that utilizes the trigger switch and performs as I stated above. Can you supply the XY-LJ02 firmware version that utilizes the trigger switch?
Author

Posts

Viewing 3 posts - 1 through 3 (of 3 total)