You are here:>>SKU 200219: Arrow Mark on Hall Sensor?
SKU 200219: Arrow Mark on Hall Sensor? 2019-10-06T16:22:28+00:00

Home › Forums › Any Other Products › SKU 200219: Arrow Mark on Hall Sensor?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • Nigel Shindler
    October 6, 2019 at 4:22 pm
    Post count: 0
    #36733 Reply |

    The Hall Sensor of the VAC9010H “bidirectional voltage and current meter” is shown on the positive battery cable with the arrow mark pointing towards the positive battery terminal in the diagrams, which I assume is the direction of a charging current in the charging mode, i.e increasing battery charge.  If the Hall Sensor was positioned on the negative cable of the battery I presume the sensor would have to be positioned with the arrow pointing away from the negative terminal?

    Nigel Shindler
    October 7, 2019 at 12:07 pm
    Post count: 0
    #36739 Reply |

    Also can you tell me how much current is drawn by the device itself when display is on?

    Drok
    Keymaster
    October 8, 2019 at 10:09 am
    Post count: 2971
    #36743 Reply |

    Hello Nigel Shindler,

    You can put negative cable into sensor, but actually it is not necessary to do that. As long as the current direction changes, sensor can check it at once.

    Meter consuming power is around 0.7W

    Best regards.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
Reply To: SKU 200219: Arrow Mark on Hall Sensor?
Your information: