You are here:>>Using Delay Module (200350) w/ Motion Sensor, to turn on 24v 20rpm Motor–help!
Using Delay Module (200350) w/ Motion Sensor, to turn on 24v 20rpm Motor–help! 2020-09-11T05:47:28+00:00

Home › Forums › Advice › Using Delay Module (200350) w/ Motion Sensor, to turn on 24v 20rpm Motor–help!

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Melissa Castellano
    September 11, 2020 at 5:47 am
    Post count: 0
    #46032 Reply |

    Hello,

    I purchased your delay module from Amazon and am trying to use a 12v-30v motion sensor (passive, but I have it powered by a 24v 2a power supply), to turn on the motor using program P5. I can’t get the motion sensor to work, because I’m not totally sure where to plug in the +/- trigger, as well as the motor. I would be very thankful for some advice, as I’ve done some light wiring in the past w/ LEDs, but I’ve never worked with motors and delay modules.

    See all components here: https://drive.google.com/file/d/1LvfGf-BB6HMZFwwATz2qllkImD7sQizi/view?usp=sharing

    Thanks so much!

    All my best,

    Melissa

     

    Drok
    Keymaster
    September 11, 2020 at 8:54 am
    Post count: 2971
    #46042 Reply |

    Hello Melissa Castellano,

    Motion sensor can send  high level signal , is it right? Is the USB cable used to power relay?

    It seems you have connected montion sensor to high level signal input port.  Have you tried to power on the relay and check if it can send trigger signal?

    About motor connection, pleawe refer to below diagram. Relay doesn’t output power for load, it just work as switch.

    You can connect independent power supply for load or relay and load share one power supply.

    For any more questions, please let us know.

    Best regards,

    DROK

     

    Best regards,

    DROK

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Using Delay Module (200350) w/ Motion Sensor, to turn on 24v 20rpm Motor–help!
Your information: