Xy-160D – not voltage on power output – Drok.Blog

HomeVoltage Regulator Support

Xy-160D – not voltage on power output 2020-11-11T16:01:33+00:00

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
Dennis
November 11, 2020 at 4:01 pm

Post count: 0

#52086 Reply |

I just received a XY-160D (L298) Motor driver. I am unable to get voltage out to either output. I am using a raspberry pi to control it and con confirm the signals are getting to the board via voltage meter. I have a 12V battery for power and 5v for logic coming from the raspberry pi.

I cannot get any voltage to read from the outputs and confirmed the motor does work if i direclty connect it to the 12v source.

Drok
Keymaster

November 12, 2020 at 7:42 am

Post count: 2971

#52132 Reply |

Hello Dennis,

How large is the signal voltage. It it also 5v?

Supply voltage for logical port must be the same as signal voltage. If supply voltage for logical signal is 5v, voltage level on EN,IN1, IN2 should be also 5v.

Best regards,

DROKI
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)