Forum Replies Created
-
AuthorPosts
-
in reply to: Battery type setup #37108
Hello Steve Ulrich,
Did you disconnect power supply completely? You need to hold “k-” button firstly and then connect power supply. Don’t release button until it show battery code.
Any more questions, please let us know.
Best regards.
Hello Frederic Dorion,
Thanks for writing in.
As we don’t have such sku number, 2019073001, it is hard to confirm which item it is.
According to your picture, we find a similar item, please check if it is correct.
200219, https://www.amazon.com/dp/B07W1W3X7D/ref=as_li_tl?tag=proeng-20
the battery level icon is not to show actual battery capacity. It can only work when you set OAH (over-capacity protection).
The percentage = (actual charging or discharging AH value /setting AH value)*100%
OAH setting: Press up or down button to move yellow cursor to OAH, then keep pressing OK button to enter parameters setting. At last, please press OK to save setting.
Best regards.in reply to: manuals for your product #37104Hello Anthony Johnson,
We think you should be talking about 090483.
Fan can be powered by input port or output port, which is decied by which jumper wire you choose.
Assume input voltage is suitable for your fan, just connect “IN” jumper wire.Best regards.in reply to: DROK Buck Converter USB Output #37103Hello Nick Triantos,
We are sorry there is no way to set USB port as default output. That is for prevent damaging your USB device , because USB port is not with fixed 5v output.
Best regards.
Hello Allen,
Thanks for sharing your experience here.
Best regards.
in reply to: Question on repeat cycle timer #37093Hello Barney,
We are sorry we can’t confirm which timer relay it is. Could you please kindly offer a product URL or ASIN number? If you order it from Amazon, you can find it from product description.
We will reply to you once confirm the item.
best regards.
in reply to: vac9010h battery percentage #37092Hello Baye Beauford,
Accroding to your description, we think it should be200219.
This battery level icon is not to show actual AH value. The percentage = (actual charging or discharging AH value /setting AH value)*100%
It can only work when you set OAH (over-capacity protection).
OAH setting: Press up or down button to move yellow cursor to OAH, then keep pressing OK button to enter parameters setting. At last, please press OK to save setting.
Best regards.in reply to: manuals for your product #37089Hello Mark Augustyn,
Thanks for writing in.
We are sorry there are not wiring diagram for it. But we mark the input and output port on item.
“Vin+” and “Vin+” is input port; ” Vout+” and “Vout-” is output port. Both of input and output are with 8 screw terminals, please connect few terminals in parallel when there is larger current. Each terminal can accept 6A.
Any more questions, please kindly let us know.
Best regards.
in reply to: dc to dc converter #37080Hello Daniel Greenfield,
We have uploaded pdf instruction on Amazon page. You can download it there.
Here is the link: https://images-na.ssl-images-amazon.com/images/I/C1QIs1zApZS.pdf
Best regards.
in reply to: Alternator output ammeter… (pre-rectification) #37079Hello,
All of our AC meter are for signal phase circuit, so far we don’t have item can meet your requirement.
Best regards.
in reply to: List of power modules with communication protocol #37078Hello ,
We are sorry we only have two buck converters with serial communication. 200220 and 200310. 200031 is also large.
Best regards.
Hello Pawel,
As this link doesn’t show which item it is, we can’t confirm which item it is.
Would you please tell us the product code or product link?
Best regards.
in reply to: Single way relay module delay swithch(SKU:200350) #37050Hello,
We are sorry to hear that. It can’t accept AC voltage. Input voltage can be only from DC power.

As it has been damaged, we would like to issue half of refund. Is it OK for you?
Best regards.
Hello Jason Blake,
We are sorry we don’t have specife wiring for wind turbine chararge controller, all of devices can refer to the same wiring diagram. But we can’t confirm which meter you mean, would you please kindly offer product link so that we can offer wiring diagram?
Best regards.
Hello anton Toth,
Thanks for writing in.
We are sorry we can’t confirm which item it is. Would you please kindly offer product link or SKU number?
We will check and find solution for you once confirm the problem.
Best regards.
-
AuthorPosts