This product is suitable for 6 ~ 60V battery charging control, can be set free start charging voltage and stop charging voltage! In the IN input charger 6-60V voltage, the OUT termination Connect the battery, for example, set 12V start, 15V stop ,when the voltage is below 12V ,the relay closes will take the charger charging voltage to the battery, when the charge voltage is greater than 15V ,The relay disconnect to stop charging, suitable for use in household chargers, solar energy, wind turbines.

• Input voltage range: DC 6 ~ 60V
• Max current: 30A
• Display resolution: 0.1V
• Control precision: 0.1V
• Voltage error: ±0.1V
• Application: 6 ~ 60V batteries
• Dimension: 84 x 60x 23mm

• 1. Connect the module to the battery, LED will display the present voltage of battery, hold press S2/SET about 3s enter setting.
• 2. Press S1/S3 will display H or L, H can set the highest limit voltage of charging, press S1/+ to increase the value, press S3/- to decrease the value, then press S2/SET to save the parameter; then set the L of lowest limit voltage of battery with the same way.
• Note: H value should be higher than L value at least 0.5V, otherwise the value cannot set.
• 3. After setting, connect the module to the power supply, hold press S2/SET to connect the relay until the red light on, which indicates it begins to charge.

• "DC +": connect to the power supply positive side
• "DC -": connect to the  power supply negative side
• "BAT -": connect to the battery negative side/ Output negative DC
• "BAT +": connect to the battery positive side/ Output positive DC.

• 1 x DC Battery Charging Control Module ( Charger/Switching Power Supply )