Forum Replies Created
-
AuthorPosts
-
Hello Bryan Barnes,
Thank you for writing in.
Would you please tell us which unit you have purchased?
We will reply to you once we confirm it.
Best regards.in reply to: Need wiring diagram for combo DC 100V 10A meter #19413Hello bjorn,
Thanks for writing in.
Are you talking about this meter?
100016
We are sorry this item must be used with a shunt.
For any more questions, please feel free to contact us.
Best regards.Hello shawn burch,
We can’t ensure the fuse specification if we don’t know the output current.
In addition, the fuse box you mention can hold maximum of 30 Amp per circuit & 100 Amp per panel, which can’t play a part of proection on our item
Best regards.in reply to: Current Transformer #19309Hello Mike,
Thanks for your information.
We are sorry we don’t have a similaar CT on sell.
Have you confirmed the problem is caused by CT? If you can,please kindly contact our customer service and tell us more details about your operation. We will try our best to find a best solution for you.
Service email: service#droking dot com ( please replace # with @)
Best regards.in reply to: 200220 DC-DC Buck converter UART #19308Hello Mitchel,
It’s glad you have made it work.
Thanks for your sharing
Best regards.in reply to: Current Transformer #19277Hello Mike,
Thank you for writing in.
We may not have the same ct for replacement.
Would you please let us know which meter you are using?
Please kindly send us the product link or ASIN number for confirmation.
Best regards.in reply to: Manual for time relay board #19276Hello Paul Norman,
Thanks for writing in.
Actually, we have uploaded manual on Amazon product page.
product link
You can find out it in the “Technical Specification” part.
Just like the attach picture showed.

If you need more help, please let us know.
Best regards.in reply to: Wiring for panel meter #19275Hello andré Lizotte,
Thanks for your cooperation.
The wires from CT to meter is better not to be extended. It may have influence on measuring result.
For more questions, please feel free to let us know.
Best regards.Hello shawn burch,
Thanks for your reply.
The fuse size is depended on input voltage and load power.
Would you pelase tell us these parameters?
Best regardsin reply to: Wiring for panel meter #19242Hello andré Lizotte,
Thanks for your business.
Do you mean this item?
200071
If not, please send us the product link for confirmation.
Best regards.in reply to: Need wiring diagram for combo DC 100V 10A meter #19240Hello Gilbert Del Rio,
Thanks for writng in.
However, we are sorry we can’t figure out what information you need and which product you are talking about.
Please tell us more details and send us the product link for confirmation.
Best regards.in reply to: 200220 DC-DC Buck converter UART #19237Hello Mitchel,
The factory default baud rate is 9600 bps.We are sorry we forget to state it.
As for other setting, we can’t ensur what setting is suitable for you,so we can’t give you an accurate answer. Hope you can understand.
Best regards.Hello shawn burch,
Thanks for your reply.
Do you mean this item?
091054
In general, we just add fuse on input positive pole. What is your purpose on adding fuse?
Best regards.in reply to: DROK® TDA8920 Subwoofer #19152Hello Philip Benton,
It’s better the current is over 4A.The voltage must be in the range of operation voltage.
Best regards.in reply to: 200220 DC-DC Buck converter UART #19132Hello Mitchel,
We think you may need a communication protocol.
200220
Best regards. -
AuthorPosts