Click Image for Gallery
- PARAMETER --- DROK audio amplifier board working voltage DC 8-26V, can be powered by the attached 12V power adapter; output power 15W+15W.
- MULTI-PROTECTIONS --- the digital amp board comes with input reverse connection protection, short circuit protection, over-heat, over-current, over-voltage, under-voltage, and EMI is allowed to pass.
- ARTIFICIAL MATERIAL --- black immersion gold circuit board, PAM8620 chip, KEMET speaker capacitor, large-capacity capacitor, black copper terminal, gold-plated audio input terminal blocks.
- OUTSTANDING PERFORMANCE --- the audio amp module is with high efficiency of over 90%, general harmonic distortion noise is less than 0.2%, low quiescent current and noise suppression.
- APPLICATION --- this power amplifier module can be used for DIY home audio stereo sound system and speaker.
1. DROK 15W+15W Audio Amplifier Module with Power Adapter
(1) Power Amplifier Board Specification:
- Working Voltage: DC 8-26V, can be powered by the attached 12V power adapter.
- Output Power: 15W stereo (24V 8ohm) / 10W stereo (12V 8ohm), if connected to 4ohm or 2ohm speaker, the power will automatically be limited to 15W.
- Input Method: single-ended (default); difference (switch by the jumper)
- Efficiency: >90%
- THD (total harmonic distortion) & noise: <0.2%
- Board Dimension: 75.69*41.96mm/2.98*1.65 inch
- Low quiescent current
- Noise suppression
- Materials: high-grade pure black immersion gold circuit board, WIMA red sound capacitor, large capacity filter capacitor. Special customized pure black copper terminals, gold-plated audio input terminals.
- Protective Functions: input reverse connection protection, short-circuit protection, over-current protection, over-heat protection, over-voltage protection, low-voltage protection, EMI is allowed to pass.
(3) Other Functions:
External mute function (MUTE: high level mute, factory default low level)
External turn-off function (SD: low-level chip turn off, factory default high level)
To use the mute/sd function, just remove the resistance next to the MUTE welding spot and add a switch between the welding spot under the resistance and the welding spot next to MUTE/SD.
Power Adapter Specification:
Output Voltage: DC 12V
1x Class-D Amplifier Board
1x 12V Power Adapter
2x Male DC Connector