Click Image for Gallery
Ask Question
It is a 75W Power Supply Module/USB Charger + Digital Meter, Input voltage: DC 6~32V, Output voltage: DC 1.25~32V, Output current: 5A Max. It has small size, high efficiency, long term stable and reliable quality,easy installation and use, Suitable for DIY an adjustable voltage regulated power supply, Charging module, Industrial equipment Voltage convert, Power Supply Transformers, Laptop Power Supply, Batteries Buck, Car Power Supply, LED drive,Advertising screen,Monitoring System etc
Parameters:- Input voltage: DC 6~32V
- Output voltage: DC 1.25~32V (Input must be 1.5 higher than output.)
- Output current: 5A Max, adjustable, recommend the use of within 4.5A. (Over 2A or 35W, please enhance heat dissipation.)
- Constant current needs above 2V output voltage, then can be adjusted. Only in the status of constant current can current adjustment work.
- Output Power: Max. 75W (recommend the use of within 50W, please reduce power if the dropout voltage is large)
- Operating temperature: -20°c ~+70°c
- Operating frequency: 180KHz
- Conversion efficiency: up to 96%
- Short circuit protection: Yes
- Input reverse polarity protection: None
- Over-temperature protection: Yes (Automatically shut off the output when over-temperature.)
- Connection: terminals or solder terminals; VIN is input; VOUT is output
- Module dimension: 65.6 x 40 x 25mm
- In the case of power off, press and hold the "SET" key and power on, then enter into voltage calibration mode, and LCD screen starts to flash, release the "SET" key;
- press "SET" and "ENT" key to increase or reduce the voltage to the right input voltage. It will automatically saves after 2s, then power off and the calibration is complete.
- Suitable for no-load with current display or slightly large current. In the case of power off, press and hold "ENT" and power on, then enter into current calibration mode and LCD screen starts to flash, release the "ENT" key; press "SET" and "ENT" key to increase or reduce the voltage to the right value. It will automatically saves after 2s, then power off and the calibration is complete.
- 1 x DC-DC Adjustable Step-down Power Supply Module with Shell
- 4 x Copper Cylinder Screws M3 x 6
- 4 x Double-pass Screws M3 x 12
- 8 x Roundhead Screws M3 x 6
Attributes | |
input voltage | 6~32V |
output current | 5A |
output power | 75W |
output voltage | 1.25~32V |
output ways | 1 |