Hello Roberto,
You’re welcome.
Adjust the output voltage and current of constant current function:
The display will display the set voltage value in default when the module is powered on. The display format of voltage is “00.00”. Pressing “SET” button can switch the to display current. The display format of current is “0.00R”. Choosing the parameter you want to adjust by “SET” button, then pressing ↑/↓button to increase/ decrease the set value. Short pressing can fine down the value while long pressing can fast set the value. After adjusting the value to the one you want, press “SET” button and then the display will become”——“, which means the current voltage/current value is stored. This value will be stored in M0 data group in default. At last, press “OK” and the output will be turned on.
In the state with output, when the module displays output voltage value, pressing ↑/↓button can adjust the output voltage value; when the module display current, pressing ↑/↓button can adjust the current value. In case with output, short press “OK” button can switch the voltage display and current display. Long-pressing for 3 seconds, the voltage and current will display in turn automatically and long-pressing again can turn it off. When the voltage and current display in turn, the ↑/↓button cannot work.
The output current is according to the need of the load in your application, which cannot be limited.
The current adjusted here is the value of constant current. If the output current is higher than this value, the module will turn into the state of constant current.
The input voltage and current cannot be limited. We can only limit the output voltage.
Hope this can help you.
Best regards
