Forum Replies Created
-
AuthorPosts
-
in reply to: manuals for your product #62196
Hello Thomas Nickle,
We are sorry we don’t have schematic, factory doesn’t offer it.
Best regards,
DROK
Hello Blake Ward,
Could you please tell us wheter it is in constant current now?
Constant voltage and constant current can’t work in the meantime. When current regulator is enable, voltage regulator compoent is disable. Only one mode is enable each time. In general, we charge battery in constant current mode firstly, when battery voltage reaches preset charing voltage, it will enter constant voltage mode.
For any more questins, please let us know.
Best regards.
in reply to: Buck converter 200310 UART levels #62061Hello Adam,
It can only accept 3.3v level.
Best regards.
in reply to: DROK 090089 Boost Converter Help? #61555Hello Steven,
Would you like to offer product link or SKU number so that we can confirm which item it is? And do you mean the item doesn’t power on?
Best regards,
DROK
in reply to: I need a 36v motor driver. #61446Hello Arvindh,
The item you found can’t drive 36v motor. For now there are no similar item.
Best regards.
Hello,
We are sorry we don’t have CAD file. Here is cut-out size for your reference.

Best regards.
in reply to: Drox 300043 malfunction? #61348Hello ,
Is the output voltage 10v when no device is connected?
If voltage is over 5.6v, decimal point will flicker. Is your like this?
Best regards,
DROK
Hello Tim J,
The connection for 200139 is different from usual meter. Please check below diagram, each two ports are shorted. So power supply is connected to the middle, load is connected to the top and bottom ports. Please check if that is available for your application.
in reply to: Calibrating #61252Hello,
We are sorry we can’t check problem from this picture. Actually, we hope to check how it works by video.
Here are few questions:
1. If the direction of load current follows the arrow on current transformer, it should be positive current. However it is negative current. Would you like to draw a simple diagram to show your connection?
2.You mentioned AH goes to 0 when charger is connected. How it is before connecting charger, can it show AH?
3. Did you set the BPC parameter successfully? If the right side is not the same as the left side, actually setting is not successfully.

4. Did you try check current with other meter? Is it is 0 A?
in reply to: AC Meter not working, help with wiring? #61177Hello Adam,
We are sorry it is hard to check whice wire pass through the current transformer. Would you like to draw a simple diagram to show the whole connection? Please kindly check again if that is load wire.
Wait for your reply sincerely.
Best regards.
in reply to: I to set gauge without decimal point #61176Hello Reynolds Marion,
Resolution ratio can’t be changed by user.
Best regards,
DROK
Hello tom somers,
Did you enable BAT? Please set the rated battery capacity and real-time capacity there.
Best regards,
DROK
in reply to: DROK 090089 Boost Converter Help? #61167Hello Robert B. Jeffery,
Here is an item for your reference, https://www.amazon.ca/dp/B07KJZNWZY?ref=myi_
Best regards,
DROK
-
AuthorPosts